Forum Rules Notice

Due to inappropriate SPAM postings, our forums are now being monitored for inappropriate content. This will cause your post to not appear publicly until it has been approved by a forum moderator. We apologize for the delay this may cause in your response, but have found it the best way to control inappropriate posts.


  Reply to this topicStart new topicStart Poll

> The Number Of Variables Allowed In An ExamView Question
chugheswaypoint
Posted: May 7 2010, 08:10 AM




Does anyone know the maximum number of variables that an ExamView question can contain?

I am trying to make a fraction that contains 3 variables with exponents in the numerator and the same 3 variables with possibly different exponents in the denominator. I want to have the students get practice reducing fractions by using the quotient property for exponents.

I want to display the original fraction where the power of 1 does not display the 1 and if a power is 0 then the variable does not display. In order to do this I have to make an equation editor equation for each scenario. I have the ability to program this, but the question will not display because I have exceeded the maximum number of variables.

An example of what I am writing about is: display (in fraction form) a^2b^3c/a^4c^2 where the power on the c in the numerator is 1 and the power on the b in the denominator is 0. The answer would display as b^3/a^2c

I have already made a similar problem. The only difference is that I kept the 0 power shown in the original fraction.

On a side note I want to suggest a format for a number as an "Exponent" format. It would be a variation of the coefficient (1st) format. The exponent format would show -1 as -1 and not show 1. This would make programming any variable with an exponent easier.
PMEmail Poster
Top
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

Reply to this topic Start new topicStart Poll

 


Copyright 1998-2008 eInstruction Corp. All rights reserved.